Home / Duck heads guide
Guides · Duck heads
Duck heads guide
A quick, high-level outline of how my duck head taxidermy prints come together, from the parts to the wall. Each model's MakerWorld page has the specifics for that design.
The parts
What you're working with
- Head: the crown, cheeks and feather texture that hold the color.
- Bill: the most delicate part, so support and handle it gently.
- Neck: where the head meets the form or mount.
- Eyes: sockets for glass taxidermy eyes or printed eyes, depending on the design.
- Some designs come in versions, like open- and closed-mouth wood duck heads, and the Shoveler drake has a rear wire slot.
- Check each model's MakerWorld page for how many parts it prints in and what it needs.
Fit
Before any glue
- Print every part in the same resin with the same settings.
- Wash, dry and fully cure every part first.
- Dry-fit the parts and check that the seam closes evenly.
- Trim or lightly sand anything that binds.
Assembly
Glue, clamp, fill
- Glue with CA glue or a two-part epoxy, following the label.
- Clamp lightly with tape or rubber bands while it cures.
- Fill the seam, then sand it flush once cured, wearing a dust mask.
- Touch up any feather texture the sanding softened.
Painting
The short version
- Prime with a thin, even coat.
- Block in the base colors from good reference photos of the real bird.
- Build iridescent head colors in thin layers. An airbrush makes the blends easier.
- Paint the bill separately with crisp edges.
- Set or paint the eyes, then seal with a matte or satin clear coat.
Mounting
Plaques and hanging
- Dry-fit the head on the plaque and mark the angle.
- Attach it with a screw or rod into solid material, or with epoxy on a flat surface.
- Use hanging hardware rated for the weight.
- Hang into a stud or a rated wall anchor.
Note: Always follow your resin's safety data sheet and the labels on your glue, filler and paint.
Dan the 3D Man